Ford P1000 Readiness Test Not Completed
Monday, 05 October 2009 12:11
P1000 - OBD readiness test not completed / EOBD drive cycle not performed

OBD II Drive Cycle

Method

1. Start the engine from cold. Engine coolant temp must be below 50°C
2. Run the engine at idle for 2½ minutes with as much electrical load as possible i.e. switch on rear demister, aircon etc…
3. Turn off all electrical items, then drive car up to 55mph using only ½ throttle.
4. Hold a steady speed of 55mph for 3 minutes.
5. Slow the car down to 20mph just by letting off the throttle, do not use the brakes, clutch or gears just coast.
6. Accelerate to 55-60mph using ¾ throttle.
7. Hold a steady speed of 55mph for 5 minutes.
8. Slow down again in the same way as step 5.

This drive cycle is valid for most vehicles but each manufacture has their own specific routine which may differ from the above.


 

This web site would like to use cookies to store information on your computer, to improve our website. Cookies used for the essential operation of the site have already been set.

To find out more about the cookies we use and how to delete them, see our privacy policy.

continue

EU Cookie Directive Module Information